MMC User Manual - AMS Neve
MMC User Manual - AMS Neve
MMC User Manual - AMS Neve
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Tools Menu<br />
Snapshot Scope<br />
Studio Configuration Page<br />
This will show a list of configurations that are available on the selected drive or disk.<br />
Click on the required configuration name in the list.<br />
It will be highlighted and the name will be shown in the Configuration to restore box.<br />
Click the Transfer File button.<br />
The Studio Configuration will be imported and will now be used to define the hardware available to Desk<br />
Setups.<br />
Snapshot Scope<br />
Snapshots allows the user to set up two independent scopes - one for Create Snap, one for Recall Snap. Both of<br />
these scopes are remembered on each entry/exit to snapshots, and also remembered with the desk setup.<br />
To set the scope to include all elements, press REC on the Master Automation Section.<br />
All available controls and processes will show red, as if in touch.<br />
To set scope to exclude all elements, press ISOL on the Master Automation Section.<br />
All available controls and process LEDs will extinguish.<br />
By default, both scopes are set to include all controls for all available processes, including faders and mutes.<br />
This type of scope setting is called subtractive, as touching controls or process buttons will remove those<br />
elements from scope.<br />
If you were now to press ISOL on the Master Automation Section, then the scope is reduced to nothing and<br />
setting the scope becomes additive, where touching controls or process keys will add that element into<br />
scope.<br />
To copy scope between paths, press the Master Panel Access key.<br />
The led will start to flash to indicate that the Copy Scope function is now active.<br />
Press and hold the Access key on the source path, then press the Access keys for destination paths.<br />
Press the Master Panel Access key to end the copy function.<br />
To keep both scopes with the desk setup, press KEEP DESK in the Utilities section.<br />
To set the Scope for a Snapshot press the CREATE SNAP (or RECALL SNAP) key.<br />
Issue 4 Page 24:42