MMC User Manual - AMS Neve
MMC User Manual - AMS Neve
MMC User Manual - AMS Neve
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The Logic <strong>MMC</strong> Console<br />
Master Section<br />
Master Automation<br />
KEEP<br />
MIX<br />
MASTER<br />
TOUCH<br />
ISOLATE<br />
MASTER<br />
TOUCH<br />
RECORD<br />
CUT<br />
AUTO<br />
FADER<br />
AUTO<br />
ISOL<br />
PLAY<br />
REC<br />
RUN<br />
AUTO<br />
TOUCH<br />
COLLECT<br />
TOUCH<br />
TO<br />
END<br />
DESK<br />
AUTO<br />
ALL/<br />
SCOPE<br />
TRIM<br />
GLIDE<br />
MASTER AUTOMATION<br />
The Master Automation keys are used for global control of dynamic automation modes.<br />
Faders Global Control<br />
A<br />
B<br />
ALL<br />
TAPE<br />
COALESCE<br />
TRIM<br />
ALL<br />
AUX<br />
AUX2<br />
SUB<br />
A<br />
SUB<br />
B<br />
ALL<br />
BUS<br />
SHOW<br />
PATCH<br />
GANG/<br />
LINKS<br />
FADERS GLOBAL CONTROL<br />
Tone<br />
Provides users with simultaneous global control of all channel strips.<br />
ON/<br />
OFF<br />
TO<br />
MTRK<br />
SELECT<br />
TO<br />
MAIN<br />
TONE<br />
The Tone panel is used to activate the tone generator. Output can be routed to Main, Tracks or via the monitor<br />
Select panel.<br />
Monitoring<br />
15<br />
13<br />
16<br />
14<br />
SELECT<br />
SELECT<br />
* *<br />
TALK<br />
TALK<br />
11<br />
12<br />
DIM<br />
9<br />
7<br />
10<br />
8<br />
SEL2<br />
HEADPHONES<br />
CUT<br />
SEL1<br />
STUDIO LS<br />
5<br />
6<br />
3<br />
4<br />
SMALL<br />
L/S 2<br />
SMALL<br />
L/S 1<br />
1<br />
2<br />
SELECT*<br />
SOLO<br />
CLEAR<br />
MONO<br />
DIM<br />
M/S<br />
MAIN<br />
GRP<br />
PHASE<br />
LEFT<br />
PHASE<br />
RIGHT<br />
CUT<br />
AUX<br />
PFL<br />
CUE<br />
EXT<br />
CUT<br />
LEFT<br />
CAL<br />
CUT<br />
RIGHT<br />
-3<br />
-6<br />
USER<br />
CONTROL<br />
ROOM<br />
LARGE LS<br />
MAIN<br />
Monitoring is controlled by three panels for Control Room, Headphones and Studio LS and Speaker Select.<br />
Issue 4 Page 3:8
Change language