REFERENCE MANUAL - FTP Directory Listing - Trimble

TRIMBLE STANDARD INTERFACE PROTOCOL (TSIP)
A
Report Packet 0x4E - Response to Set GPS Time
Indicates whether the receiver accepted the time given in a Set GPS time packet. the
receiver sends this packet in response to Packet 0x2E. This packet contains one byte.
Table A.35
Value
ASCII “Y”
ASCII “N”
Report Packet 0x4E Data Formats
Meaning
The receiver accepts the time entered via Packet 2E. The
receiver has not yet received the time from a satellite.
The receiver does not accept the time entered via Packet
2E. The receiver has received the time from a satellite and
uses that time. The receiver disregards the time in Packet
0x2E.
Report Packet 0x55 - I/O Options
These abbreviations apply to the following table: ALT (Altitude), ECEF (Earthcentered,
Earth-fixed), XYZ (coordinates), LLA (latitude, longitude, altitude), HAE
(height above ellipsoid), WGS-84 (Earth model (ellipsoid)), MSL geoid (Earth (mean
sea level) mode), and UTC (coordinated universal time).
Table A.36
Command Packets 0x55 and 0x35 Data Descriptions
Byte Bit Item Type Value Definition
Position
0 0 XYZ ECEF Bit 0
1
0 1 LLA Output Bit 0
1
0 2 LLA ALT Output Bit 0
1
0 3 Reserved
0 4 Precision-ofposition
output
0 5 Super Packet
Output
Bit 0
1
Bit 0
1
0 6-7 Reserved
Velocity
1 0 XYZ ECEF Bit 0
1
1 1 ENU output Bit 0
1
1 2-7 Reserved
Timing
2 0 Time Type Bit 0
1
1-4 Reserved
5-6 PPS Mode
XYZ ECEF output off
XYZ ECEF output on
LLA output off
LLA output on
HAE (WGS-84 datum)
MSL geoid
Send single-precision packet.
Send double-precision packet.
Output no Super Packets.
Output all enabled Super
Packets.
XYZ ECEF output off
XYZ ECEF output on
ENU output off
ENU output on
GPS Time
UTC
Copernicus GPS Receiver 147