REFERENCE MANUAL - FTP Directory Listing - Trimble

STARTER KIT 1
Configure PPS Output
1. Select the Configure pull down menu from the main screen.
2. Select Receiver Configuration.
3. Select the PPS Configuration tab.
Note – Always ON – the PPS is present even without a GPS fix, it will free run until
fix is obtained. Fixed-based – the PPS will only be output when the receiver has a fix.
4. After selecting the required setup options, click on Set.
5. If the configuration is to be permanent, click Save Configuration.
Configure NMEA Output
1. Select the Configure pull down menu from the main screen.
2. Select Receiver Configuration.
3. Select the NMEA tab.
4. After selecting the required setup options, click on Set.
5. If the configuration is to be permanent, click Save Configuration.
Copernicus GPS Receiver 25