REFERENCE MANUAL - FTP Directory Listing - Trimble

STARTER KIT 1
Removing the Reference Board from the Interface Unit
Follow this procedure to remove the Copernicus GPS reference board from the
interface unit:.
1. Before disassembling the interface unit, disconnect the unit from any external
power source and confirm that both you and your work surface are properly
grounded for ESD protection.
2. Remove the four screws, which secure the bottom plate of the interface unit to
the base of the metal enclosure. Set the bottom plate aside.
3. Remove the two screws securing the Copernicus GPS reference board to the
standoffs. These screws are located at opposite ends of the receiver module.
Copernicus GPS Receiver 13