REFERENCE MANUAL - FTP Directory Listing - Trimble
REFERENCE MANUAL - FTP Directory Listing - Trimble
REFERENCE MANUAL - FTP Directory Listing - Trimble
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TRIMBLE STANDARD INTERFACE PROTOCOL (TSIP)<br />
A<br />
Command Packet 0x8E-20 - Request Last Fix with Extra Information<br />
This packet requests Packet 0x8F-20 or marks it for automatic output. If only the first<br />
byte (20) is sent, an 0x8F-20 report containing the last available fix will be sent<br />
immediately. If two bytes are sent, the packet is marked/unmarked for auto report<br />
according to the value of the second byte as shown in below. 0x37 can also be used<br />
for requesting 0x8F-20 if the 0x8F-20 is scheduled for auto output.<br />
Table A.60<br />
Command Packet 0x8E-20 Field Descriptions<br />
Byte Item Type Definition<br />
0 Sub-packet id UINT8 0x20<br />
1 Mark for Auto-report (See Packet<br />
35 byte 0 bit 5)<br />
UINT8<br />
0 = do not autoreport<br />
1 = mark for autoreport<br />
Note – Auto-report requires that superpacket output is enabled. Refer to Command<br />
Packet 35.<br />
Command Packet 0x8E-26 - Non-Volatile Memory Storage<br />
The 0x8E-26 command is issued with no data to cause the current settings to be saved<br />
to non-volatile memory. The 0x8F-26 report is generated after the values have been<br />
saved.<br />
Table A.61<br />
Command Packet 0x8E-26 Definitions<br />
Byte # Item Type Value Definition<br />
0 Subcode UINT8 0x26 Save Settings<br />
Command Packet 0x8E-2A - Request Fix and Channel Tracking Info, Type 1<br />
This packet requests Packet 0x8F-2A or marks it for automatic output. If only the first<br />
byte (packet sub-code 0x2A) is sent, an 0x8F-2A report containing the last available<br />
data will be sent immediately. If two bytes are sent, the packet is marked/unmarked<br />
for auto report according to the value of the second byte as shown in below.<br />
To retain the auto-report setting for this packet, first set the setting accordingly and<br />
then save to non-volatile memory by issuing the packet 0x8E-26.<br />
Table A.62<br />
Command Packet 0x8E-2A<br />
Byte Item Type Value Definition<br />
0 Packet sub-code UINT8 0x2A Packet sub-code<br />
1 Mark for Autoreport<br />
UINT8 0,1 0 = do not auto-report<br />
1 = mark for auto-report<br />
Copernicus GPS Receiver 167