ExpressCluster X 2.0 for Windows Reference Guide - Nec

Chapter 3 Function of the Builder
130
� Password for Operation
Set a password to connect to the WebManager in the operation mode. Click Change to
display the Change Password dialog box.
� Password for Reference
Set a password to connect to the WebManager in the reference mode. Click Change to
display the Change Password dialog box.
• Old Password:
Enter the current password. If the password is not set, leave it blank.
• New Password:
Enter a new password. When deleting the old password, leave it blank.
• Password Confirmation:
Enter the password again which you entered in New Password.
Control connection by using client IP address MStopRestart
If selected, accesses are controlled by client IP addresses.
� When selected:
Add, Remove and Edit buttons are enabled.
� When cleared:
Add, Remove and Edit buttons are disabled.
Add MStopRestart
Use Add to add an IP address in IP Addresses of the Accessible Clients. By clicking Add, the
IP Address Settings dialog box is displayed to enter an IP address. Newly added IP addresses
have the rights for the operation.
ExpressCluster X 2.0 for Windows Reference Guide