ExpressCluster X 2.0 for Windows Reference Guide - Nec

Chapter 4 ExpressCluster command reference
Shutdown hook configuration command
328
clphookctrl
Command line:
clphookctrl -s [-m mode]
clphookctrl -m mode
clphookctrl -t
The clphookctrl command configures the shutdown hook function.
Description This command configures the function which hooks the OS shutdown
process to execute node shutdown or restart of ExpressCluster. By using this
function, OS shutdown or restart can be performed after successfully
terminating or moving the operating failover group when OS shutdown is
performed by other than ExpressCluster.
Option -s Enables the shutdown hook function.
-t Disables the shutdown hook function.
-m mode Configures the process to be executed after the OS
shutdown hook. Specify either of the following for
mode:
SHUTDOWN Server shutdown (preset value)
REBOOT Server restart
Return
Value
0 Completed successfully.
Other than 0 Terminated due to a failure.
Notes This command must be executed by a user with the administrator
privilege.
The configuration by the -s option is enabled when the ExpressCluster
Server service is started next time. Configuration by other options are
enabled immediately.
Shutdown hook function cannot be used in Windows Server 2008.
Examples If there is a possibility that OS shutdown is executed by the application
or middleware other than ExpressCluster, you can cancel the OS
shutdown to perform ExpressCluster server shutdown by executing the
following command in each cluster server.
# clphookctrl -s
Note that in this case although OS restart is executed, it is shut down so
that the server is not restarted. Upon restarting the OS, it is required to
execute the following command to change the operation settings in
advance.
ExpressCluster X 2.0 for Windows Reference Guide