ExpressCluster X 2.0 for Windows Reference Guide - Nec

Section I Detailed functions of ExpressCluster
Terminating the application or service (armkill command)
Terminating the application or service (armkill
command)
armkill.exe: the armkill exe command terminates the application or service.
Command line:
armkill.exe watchID [/C | /T time]
Description
Parameter
Return Value
This command terminates the application or service that was started up
by the ARMLOAD command.
When one service is operated (monitoring target) with several
ARMLOAD commands (when several ARMLOAD commands with /A
option operate one service), the service is not terminated until
ARMKILL is run for all watchID.
watchID
/C
/T time
Specifies the monitoring ID of the application or service
you want to terminate.
Use the ID specified when the application or service was
started up by the ARMLOAD command.
Cancels the monitoring of the application or service but
does not terminate the application or service.
This parameter is optional. When omitted, the application
or service is terminated. This parameter cannot be specified
with the /T parameter.
Sets the termination wait time of the application or service.
The range that can be specified is from 0 to 3600 seconds.
If 0 is specified, the command waits for the completion of
termination of the application or service endlessly. This
parameter is optional. When omitted, the wait time is set to
40 seconds. This parameter cannot be specified with the /C
parameter.
0 Success (the target application or service was terminated).
1 The application or service has already been terminated.
2 The application or service was not terminated.
(The application or service is being terminated.)
8 The ExpressCluster Server service has not been started.
9 The parameter is invalid.
343