ExpressCluster X 2.0 for Windows Reference Guide - Nec

Chapter 1 Functions of the WebManager
80
Level Message Cause Solution
Error Operatable group
does not exist.
Error Enter the number of
alert logs displayed on
each page.
The operation to the group
failed.
The number of the alert log
filter result to be displayed
(for example, the number of
logs in a window) is not set.
continued.
Solve the problem that
caused the failure of the
operation to the group.
For the detailed
information on the error,
see the alert log.
Specify the number of
the alert log filter result
to be displayed.
Error Enter the event ID. The ID for alert log search is Specify the ID for alert
not set.
log search.
Error Enter the module The name of the module for Specify the name of a
name.
the alert log search is not module for the alert log
set.
search.
Error Enter the number of The number of alert logs to Specify the number of
searches.
be searched is not set. alert logs to be searched
for.
Error Enter the page The page to show the Specify the page to
number.
results of the alert log show the results of the
research is not set.
alert log research.
Error Enter the server The name of a server for Specify the name of the
name.
alert log search is not set. server to be searched
for.
Error The selected server is The server specified as the Wait for a while to
invalid.
destination for moving the perform reloading to
group is invalid.
update the group status,
and then perform the
operation to the group.
Error Specified server is not The server that initiated the Wait for a while to
active.
operation is not active. perform reloading to
update the group, and
then perform the
operation.
Warning The cluster tree An error occurred while Try reloading later.
obtained from server
may not be
completed.
acquiring the server status.
Error The number of alert The specified number of Specify a value between
logs per page you alert log filter results 1 and 300.
have entered is not in displayed per page is out of
the specified range
(1~{0}).
the range.
Error The value in “To” is The time specified for end of Set a correct time.
incorrect.
alert log search is invalid.
Error Event ID entered is The ID set for alert log Specify a value of 1 or
less than 1.
search is smaller than one. greater.
Error There are no groups Failed to start up a group. Solve the problem that
that can be started.
caused the failure of the
operation to the group.
For the detailed
information on the error,
see the alert log.
Error There are no groups Failed to stop the group. Solve the problem that
that can be stopped.
caused the failure of the
operation to the group.
For details on the error,
see the alert log.
Error There are groups that Some operations failed. Run a command to
failed to start.
check the server status.
If there is no problem,
ExpressCluster X 2.0 for Windows Reference Guide