ExpressCluster X 2.0 for Windows Reference Guide - Nec

Chapter 6 Group resource details
416
� When Follow the default dependence is not selected:
The selected group resource depends on the specified resource.
Add SuspendResume GroupStopRestart
It is used when adding the group resource selected in Available Resources to Dependent
Resources.
Remove SuspendResume GroupStopRestart
It is used when removing the group resource selected in Dependent Resources from Dependent
Resources.
Displaying and changing the operation settings when a group
resource error is detected
You can display and change the operation settings of actions when a group resource error is
detected (when group resources are active/inactive) by using the Settings tab of the Builder.
1. In the tree view shown in the left pane of the Builder, click the icon of the group to which
the group resource you want to display or change whose behavior at the time when a group
resource error is detected belongs.
2. The list of group resources will be shown in the table view on the right pane. Right-click the
group resource you want to view or set whose behavior at the time when a group resource
error is detected. Click Properties, and then click the Settings tab.
3. Specify the behavior at the time when a group resource error is detected by following the
procedures below:
� When an error in activation of the group resource is detected:
When an error is detected while activating the group resource, try activating it again.
When the activation retry count exceeds the number of times set in Retry Count at
Activation Failure, failover to the server specified in the Failover Target Server is
executed.
When the group resource cannot be activated even after executing a failover as many
times as specified in Failover Threshold, the final action is taken.
� When an error in deactivation of the group resource is detected:
When an error is detected while deactivating the group resource, try deactivating it again.
When the deactivation retry count exceeds the number of times set in Retry Count at
Deactivation Failure, the final action is taken.
ExpressCluster X 2.0 for Windows Reference Guide