Reference Manual - Videx, Inc.

1.2.Resetting a Web AuthorizerResetting an Authorizer will revert it back to the original, unprogrammed state as it wasshipped from the factory. To reset a Web Authorizer:Disconnect the power and all other cables from the rear of the Authorizer.Use a single Ethernet cable to bridge the ports labeled Keyport1 and Keyport2.3.Reapply power to the Authorizer. The LEDs on the front of the Authorizer will cycle throughthese startup steps:Power LED only - InitializingPower and 1 - Loading software components from memoryPower and 2 - Acquiring network, starting software components and applicationPower solid and 1, 2 flashing - Scanning USBWhen Power stays solid and 1 flashes about once every 4 seconds, the system is operatingnormally. At this point it is ready to configure.Additional links:Web Authorizer DescriptionInstalling a Keyport (see Installing a Keyport.pdf)Steps to add a Web AuthorizerAudit Trail Events