Reference Manual - Videx, Inc.

Vault 20 FX Demo ModeUntil it has been paired with a CyberAudit?Web system, the Vault 20 FX will boot into demomode when power is connected to the cabinet. This allows for verification and demonstrationof basic system operation.Entering Demo ModeConnect power to the cabinet. The display will briefly show the Videx logo, thenthe word "READY" for about 15 seconds.At this point, the Vault is ready for demonstration. If no action is taken, the displaywill show the Videx logo again, then go black after about 20 seconds.Inserting KeysNote:The Vault 20 FX accepts CK-RXD CyberKeys.Scan an RFID card or enter four or more digits on the keypad, followed by #. Thecabinet will beep and release the door latch. The keypad display will show a mapof the key locations inside the cabinet. The letter o represents an open socket.Open the door.Insert a key into any open socket. The display will briefly show DOWNLOAD KEY. . .. . . and then KEY IN.Repeat Step 3 for each key, until all keys have been inserted.Close the door. The display will showREADY, then go black after 20 seconds.Note: If the door is held open for longer than 1 minute, the light in the center of the RFID reader modulewill change from green to red, and the cabinet will begin to beep. This is the "Door Open" alarm. Tosilence it, close the door.