Reference Manual - Videx, Inc.

Firmware - Indicates the version number of the software running in the hub. This field willdisplay only after CyberAudit-Web communicates with the hub and captures thisinformation.Demo Mode - Check this box as the first step to setting the Vault 20 FX hub into demomodeUpdate Frequency - By default a Vault 20 FX checks in for updates with CyberAudit-Webonce every 30 seconds. In some cases where there is a per-byte cost of datatransmission, it may be desirable to reduce the frequency of check-in. CyberAudit-Webdoes attempt to make an immediate TCP/IP connection with the Vault 20 FX when anupdate is pending for the hub. If the connection attempt is successful, the Vault 20 FX willimmediately synchronize with CyberAudit-Web rather than waiting for the next check-intime. However if it is not possible to make that connection, the administrator should beaware that any pending updates the hub affecting configuration or access permissionsmay be delayed until the hub successfully checks in with CyberAudit-Web.Alarm if open longer than - If the door on the Vault 20 FX is left open for longer than thespecified time it will cause the beeper in its RFID module to beep repeatedly as a warningto close the door.NetworkingCyberAudit-Web Server Address - The IP address or domain name of theCyberAudit-Web server. If the subsystem preference will be used, the checkbox will bechecked.Automatic (DHCP) / Manual - Choose the settings appropriate to the subnet where thehub will be installed.Push Notification Port - The network port on the Flex System hub that listens for aTCP/IP signal from the CyberAudit-Web server. This signal tells the hub to immediatelycontact CyberAudit-Web for instructions.Proxy - Many larger networks require web browsing to be routed through a proxy server toreach the Internet. Because the Vault 20 FX is fundamentally a web client, its web trafficmust also be routed through the proxy. If a proxy server is required, its information must beentered here.Note: Once a CyberKey Vault 20 FX has been added and configured, changes to theProxy settings may only be updated by programming its hub from a USB flash drive.