Reference Manual - Videx, Inc.

791011121314Master keyauthorizedProgrammer orCyberPointcontactLock resetattemptedUnprogrammedlock -authorizedNo lock ID -authorizedKey in lockmore than 1minute -orremovedfromlockAccess codefailedProgrammer contact -or- Contact with lock using a CyberPoint schedule. Keybeeped 3 times.Subsystem reset keys only.If a key is operating within its key schedule (i.e. not expired) and if the key is notdisabled, it is automatically authorized to open a lock that is not programmed.This event should never occur. It indicates that the lock was not set up with an ID.It cannot be programmed and will not function in a CyberAudit system.Keys in a subsystem may be configured to report all "removed from lock" events.The message text will depend on this settingThis message will occur if:*A lock contains different access codes than expected by the databasebecause it has been moved to or from a different database.The lock has been updated with new access codes but the key has not.The lock does not contain the access code that a master key isprogrammed to use.15Keyauthorizationfailed/blockedby lockThe key has been disabled either by:1.2.The lock because the key was designated as "lost" and the lock wasdesignated as a disabling point orDisabled when updating and removed from the communicator beforeupdating was complete.1617Hardwaremismatch -access deniedOut ofschedule forlockThis event should never occur. It indicates manufacturing difference between lockand key.The key found the lock ID in its lock list but the time of contact with the lock wasnot during the associated schedule valid operating time.the time frame did not match the current timethe day did not match the current dayit is before the schedule is to beginthe schedule has expired18Key expired orout of scheduleIf it is a master key, it could generate this event if:the key schedule time frame did not match the current timethe key schedule day did not match the current dayit is before the key is to begin operatingthe key has expired