Reference Manual - Videx, Inc.

Messages at setup and administrationUser interactionsSystem messages and errorsFlex System Display MessagesMessageUNKNOWNUSBDEVICELOAD NETSETTINGSBAD NETSETTINGSBADPROXYSETTINGSBADCONFIGDOWNLOADSTATUSDOWNLOADFLEXEVENTSDOWNLOADKEYEVENTSUSBREADYCHECKUSBFORMATBADUSBFORMATDescriptionMessages at Setup and AdministrationA USB device was not recognized as a mass storage type by the Flex System hub.The Flex System hub is loading network settings from a USB configuration. Thismessage normally will not be seen because the process happens very quickly.The USB network configuration settings failed an integrity check.The proxy settings received from USB failed an integrity check.The USB configuration file failed an integrity check.Indicates the Flex System hub is writing its status and diagnostic information to a USBflash drive.Indicates the Flex System hub is writing its audit trail events to a USB flash drivebased on instructions received in the fetch diagnostics page.The Flex System hub successfully wrote the requested data to the USB flash drive.The drive may now be removed.The Flex System hub discovered a newly inserted USB flash drive and is determiningwhether it can decipher the format of the drive.The Flex System hub could not decipher the format of the newly inserted USB flashdrive.MessagePIN"BAD PINENTERNEW PINCONFIRMNEW PINREADYREADY*BUSYDescriptionUser InteractionThe person record was found and requires a PIN be entered to validate identity.The PIN entered does not match the PIN on record for the identified person.The user has been identified by RFID card scan or mission number and must create anew PIN. At this point 4 to 8 digits must be entered followed by the ,#,.The user has just entered a new PIN and must enter the new PIN again to confirm it iscorrect.The Flex System hub is idle but it does not have a connection with CyberAudit-Web.The Flex System hub is idle and has a connection to CyberAudit-Web.The Flex System hub is processing a command or request.