Reference Manual - Videx, Inc.

GeneralName - The name assigned to the Flex System Hub. This name appears in the AccessMatrix for the purpose of granting access to any connected Weatherized Vaults.ID - The serial number of the hub assigned at the factory. Flex System Hub IDs have theformat OXXXXXXXX.Firmware - Indicates the version number of the software running in the hub. This field willdisplay only after CyberAudit-Web communicates with the hub and captures thisinformation.Demo Mode - Check this box as the first step to setting the Flex System hub into demomodeUpdate Frequency - By default, Flex System Hubs check in for updates withCyberAudit-Web once every 30 seconds. In some cases where there is a per-byte cost ofdata transmission, it may be desirable to reduce the frequency of check-in.CyberAudit-Web does attempt to make an immediate TCP/IP connection with the FlexSystem Hub when an update is pending for the hub. If the connection attempt issuccessful, the Flex Hub will immediately synchronize with CyberAudit-Web rather thanwaiting for the next check-in time. However if it is not possible to make that connection, theadministrator should be aware that any updates the hub affecting configuration or accesspermissions may be delayed until the hub successfully checks in with CyberAudit-Web.NetworkingCyberAudit-Web Server Address - The IP address or domain name of theCyberAudit-Web server. If the system default from communicator options will be used, thecheckbox will be checked.Automatic (DHCP) / Manual - Choose the settings appropriate to the subnet where thehub will be installed.Push Notification Port - The network port on the Flex System hub that listens for aTCP/IP signal from the CyberAudit-Web server. This signal tells the hub to immediatelycontact CyberAudit-Web for instructions.Proxy - Many larger networks require web browsing to be routed through a proxy server toreach the Internet. Because the Flex System hub is fundamentally a web client, its webtraffic must also be routed through the proxy. I If a proxy server is required, its informationmust be entered here.Note: Once a Flex System hub has been added and configured, changes to the Proxysettings may only be updated by programming the hub from a USB flash drive.