Reference Manual - Videx, Inc.

CyberLink Result CodesCyberLink gets result codes from the IR Encoder, USB Station , and Web Station duringcommunications. Many are not directly seen by the user interface. Some results may beinterpreted as errors. Below is the complete list of result codes.Result CodeDescription40 Disconnected - Key is no longer present41 Device reset42434445464748494A4B4C4D, 4E4FFile Not Ready - The communicator has not finished downloadingthe key yet.Wrong Key ID - The current key ID does not match the key IDwhen the session started.Wrong key system code - A database identifier in the instructionsfor the key does not match the identifier in the key.Key file system disabled - The CyberKey will not acceptinstructions because its file system has been disabled.Bad File ID - The CyberKey has rejected a configuration file withan ID that matches the key's current configuration but the file sizeis different.Older File - The CyberKey has rejected a configuration file with anID older than the key's current configuration.File too large - The CyberKey has rejected a configuration filebecause it exceeds 32K.Bad File - The CyberKey has rejected a configuration file becauseit failed the integrity check (product ID, version, or CRC).Too many files - The CyberKey has rejected a configuration filebecause its file system is full.Write Failed - The communicator could not write to the key'smemory.Encryption ErrorIllegal Command - A command contained in the configuration isillegal for the communication mode.Bad Firmware Update File - The IR Encoder, USB Station, or WebStation has rejected a firmware update file because of a meta dataerror.50 Key Communications Interrupted - No response from key.51Wrong Firmware Update File - The IR Encoder, USB Station, orWeb Station has rejected a firmware update file because it was afile intended for another device. For example, this error wouldoccur if IR Encoder firmware were sent to a USB Station.