03.05.2016 Views

Cirrus SR2x

fV4OKB

fV4OKB

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

SYSTEM OVERVIEW<br />

1.6 DISPLAY BACKLIGHTING<br />

The dimming bus is the primary source for backlighting adjustments of the PFD and MFD displays, bezel, Audio<br />

Panel keys, AFCS Control Unit keys, and PFD/MFD Control Unit keys. The automatic backlighting adjustment<br />

for the AFCS Control Unit annunciators and PFD/MFD Control Unit annunciators uses photocell technology to<br />

automatically adjust for ambient lighting conditions. Photocell calibration curves are pre-configured to optimize<br />

display appearance through a broad range of cockpit lighting conditions. Manual backlighting adjustment can<br />

be accomplished using the existing instrument panel dimming bus or the following procedures. In normal<br />

operating mode, backlighting can only be adjusted from the PFD. In Reversionary Mode, it can be adjusted from<br />

the remaining display.<br />

Adjusting display backlighting:<br />

1) Press the PFD MENU Key to display the PFD Setup Menu. ‘AUTO’ is now highlighted next to ‘PFD DSPL’.<br />

2) Turn the small FMS Knob to select ‘MANUAL’.<br />

3) Press the ENT Key. The intensity value is now highlighted.<br />

4) Use the FMS Knob to enter the desired backlighting then press the ENT Key.<br />

5) Turn the large FMS Knob to highlight ‘AUTO’ next to ‘MFD DSPL’ and repeat steps 2-4.<br />

6) To remove the menu, press the CLR or MENU Key.<br />

Adjusting key backlighting:<br />

1) Press the PFD MENU Key to display the PFD Setup Menu. ‘AUTO’ is now highlighted next to ‘PFD DSPL’.<br />

2) Turn the large FMS Knob to highlight ‘PFD DSPL’.<br />

3) Turn the small FMS Knob in the direction of the green arrowhead to display ‘PFD KEY’.<br />

4) Turn the large FMS Knob to highlight ‘AUTO’.<br />

5) Turn the small FMS Knob to select ‘MANUAL’.<br />

6) Press the ENT Key. The intensity value is now highlighted.<br />

7) Use the FMS Knob to enter the desired backlighting and press the ENT Key.<br />

8) Turn the large FMS Knob to highlight ‘MFD DSPL’.<br />

9) Turn the small FMS Knob in the direction of the green arrowhead to display ‘MFD KEY’ and repeat steps 4-7.<br />

10) To remove the menu, press the CLR or MENU Key.<br />

PFD<br />

SYSTEM<br />

OVERVIEW<br />

FLIGHT<br />

INSTRUMENTS<br />

EIS<br />

AUDIO PANEL<br />

& CNS<br />

FLIGHT<br />

MANAGEMENT<br />

HAZARD<br />

AVOIDANCE<br />

AFCS<br />

ADDITIONAL<br />

FEATURES<br />

APPENDICES INDEX<br />

Figure 1-43 PFD Setup Menu<br />

190-00820-11 Rev. A Pilot’s Guide for the <strong>Cirrus</strong> <strong>SR2x</strong> with <strong>Cirrus</strong> Perspective by Garmin 55

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!