Instructions for use: Ikus - Berlin Heart

INDEX
Driving units 88
DT, Destination therapy 5
E
Electro-stimulation therapy 4
EMC 3, 101
Electromagnetic immunity 102, 103
Electromagnetic radiation 3
Emissions characteristics 101
Emergency log 96
Emergency operating mode 17, 70
Emergency pulse mode 79
Entry code: see user profile
Error
during self-test 33
during start test 73
Error messages
Alarm circuit fault – horn remains off (or on) 65
Backup operation left/right 66
Batteries discharged; battery mode not possible 64
Connect the driving tube 65
Do not operate the driving unit without supervision!
66
Emergency operating mode 70
Emergency operating mode due to empty batteries -
threat of total failure! 70
Error : no data⁄ no reaction from the control processor
69
Error during start test 73
FATAL: Battery failure! Inform Service urgently! 68
Fault: () 66
Faulty connection to the laptop (during start test)
73
Faulty connection to the laptop (outside of the start
test) 73
Left/right flow sensor defective. Contact Service department!
69
No internal communication 70
Please check the tube and the left/right pump 66
Pressure error/time error in the system 67
Processor failure. Contact service! 71
System 1 (or 2) is faulty 71
System 3 is faulty 72
The acoustic alarm is not correctly detected 64
The error is only detected by the active (or passive)
controller 69
The self-test is not ended by the passive processor
71
Throttle valve error in the system 67
Updating the parameter block failed 64
Exiting the
monitoring program 21
Explantation 61
External alarm (nurse call) 14
F
Failure of the control processors 82
Failure of the power supply 82
H
Hemolysis 4
I
Identification plate 90
Ikus
Commissioning 31
Connection panel 14
Description 13
emergency log 96
Instructions for use 19
Overview 13
Preparation outside of the operating room 31
Routine start test
Single-step mode 36
Storage 6
Transport 29
Transportation 6
Implantation 41, 45
EXCOR implantation record 91
Intraoperative drive management 33
Implantation record 91
Indications 5
Infections 4
Information message: System has reached maximum
capacity 72
Inspection
Monitoring program 60
Parameter 60
Pump filling 59
Pump, deposits 59
Intensive care 53
K
Key switch (main switch; O/I) 14
L
Laptop 13
see also monitoring program
Log file 63
Logging the
parameters 60
x 1000002 Rev 4.9.1
M
Magnetic resonance imaging 3, 4
Main switch (key switch; O/I) 14
Mains power 3, 15, 27
Mains power operation
Battery fuse 83
Maintenance 7
Manual pump 17, 81
Maximum capacity 72
Membrane set 42, 88
Message window 22, 24