Instructions for use: Ikus - Berlin Heart

Error messages during the start test
Error messages and corrective action
11.27.3 Additional messages during the start test
If the Ikus detects an error during the start test, one of the following messages appear
in the message window depending on the nature of the error:
• Problem: Batteries have very different charge levels.
• Problem: Battery controller.
• Problem: Defective mains power supply. Please inform Service.
• Problem: Laptop! Please inform Service.
• Problem: Power circuit - inform Service.
• Problem: Power supply sensor defective. Inform Service.
• Problem: Power supply voltage - check mains connection.
• Problem: Defective mains power supply. Please inform Service.
• Problem: Error in WR2/ circuit board.
• Problem: Circuit 1 defective. Inform Service.
• Problem: Circuit 2 defective. Inform Service.
• Problem: WR1 does not switch. Inform Service.
Restart the Ikus
Instructions
1. According to the display:
If necessary: enter to read message; go back by pressing .
Essential: enter or to exit the monitoring program. A second window appears.
2. Second window: According to the display, select the option . The monitoring
program writes a log file and is terminated. Wait until the message “You can now switch
off the drive.” appears.
3. Switch off the key switch and then switch it back on again.
If the Ikus now ends the start test without a message:
Start up the Ikus.
If one of the above messages appears again:
Do not start up the Ikus.
Notify hotline! +49(0)30 8187 2772
74 1000002 Rev. 4.9.1