work plan for soil remediation, sampling and analysis plan, site ...

OHM RemediationServices Corp. HEALTH AND SAFETY PLAN3.4 TASK-SPECIFIC RISK ASSESSMENT/ACTIVITY HAZARDANALYSISPrior to beginning each major phase of work, an activity hazard analysis (form included inAppendix E) will be performed. The analysis will define the activity being performed, identifythe sequence of work, the specific hazards anticipated and the control measures to beimplemented to eliminate or reduce each hazard to an acceptable level.Work will not proceed on that project phase until the activity hazard analysis has been acceptedby the designated on-site authority, as well as being discussed with all site personnel that willperform the activity. The following Task-Specific Risk Assessment/Activity Hazard Analysisidentifies the major project phases and anticipated hazards to be encountered and controlmeasures that will be instituted during the execution of the scope of work, previouslyapproved by LANTDIV for this project.II Task Breakdown I PotentialI HazardsTask No. 1:Mobilizationand Site PrcparatonStruck by, AgainstHeavy Equipment,FIying Debris,Protruding ObjectsHazard Control Measures. Use reflective warning vests when exposed to vehicular traffic. Isolate equipment swing areas. Make eye contact with operators before approaching equipment. Restrict entry to the work area to authorixd personneI. Wear hard hats, safety glasses with side shields, or splash/face shields and goggles, andsteel-toe safety boots at all times. Understand and review posted hand signalsHandlingObjectsEleariczdHeavyShock. Observe proper lifting techniques. Obey sensible lifting limits (60 pounds maximum per person manual lifting). Use mechanical lifting equipment (band carts, tmcks) to move large awkward loads. Do not exceed equipment/crane load specifications when hoisting loads. Do not suspend loads over ground personnel. De-energize or shut off utility lines at their source before work begins. Use double insulated or properly grounded electric power-operated tools. Provide an equipment-grounding conductor program or employ ground-fault circuitillbXNptErS. Use qualified elect&ians to hook up electrical circuits. Insped alI extension cords daily for StNCtUId integrity, ground continuity, and damaged.insulatialCover or elevate electric wire or flexible cord passing through work anzas to pm-from damage. Keep all plugs, cords, and receptacles out of water. Use approved water-proof, weather-proof type if exposure is likely. Inspect all electrical power circuits prior to commencing work. Follow Lockouflagout procedures in accordance with OHM Health and SafetyProcedures ManualSlips, Trips,Falls. Clear walkways of equipment, construction debris and other materials. Mark, identify or banicade @her obstructions. Use body harness and lifeline when working 6 feet or more above the ground. Use approved ladders in accordance with OHM Health and Safety Pmcedures ManualOHM Preject 16487SSHSP Health and Ssfety F’lsn July 1995Information herein is preprietsry and confidential and to be used or released to others only with explicit writl~ permission of OHM RanediationServices Corp.3-16