User Manual 08/2003 Edition

02.99 04.01
5.6.2 List of parameters
Explanation of the
parameter list
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition
5.6 Parameters for SIMODRIVE POSMO A
Reader’s note
The parameters, listed in the following, are valid for all software
releases of SIMODRIVE POSMO A.
The complete list is updated corresponding to the Edition of the
documentation (refer to the Edition status in the header line) and
corresponds to the software release of SIMODRIVE POSMO A
documented here.
The parameters that are dependent on the software release are
appropriately identified.
The parameters are shown in the parameter list as follows:
Parameter number (examples)
P0010 Parameter 10 without index
P0082:28 Parameter 82 with index 0, 1, ... 27 (28 indices)
P0082:13 Parameter 82 with index 13
P0082:x Parameter 82 with undefined index x
P0056.2 Parameter 56 bit 2
decimal hexadecimal
Pdddd || hh word_word word_word
075W 300W
Min Standard Max Units Data type Effective
xx xx xx xx yy zz
Parameter description
Motor type
Specifies for which motor the parameter is
valid.
075W ––> 75 W motor
300W ––> 300 W motor
Units
MSR: Measuring system grid
1 MSR = 1 mm for P4 = 0
1 MSR = 1 degr. for P4 = 1
1 MSR = 1 inch for P4 = 2
Fig. 5-20 Parameter list
Parameter text
5 Description of the Functions
Data type
––> Refer to Chapter 4.3.1
Effective
immediately ––> becomes immediately
effective when a change is made
When a parameter is changed, the motor must
always be stationary. If a parameter can be changed
while the axis is traversing, then an explicit reference
is made.
RO ––> Read Only
The parameter can only be read and not written into.
5-183
5