User Manual 08/2003 Edition

Index
A
Abbreviations, A-239
Acknowledging faults, 6-215
Address, 2-39, 2-42
Documentation (Fax, email), v
Internet, v
Technical Support, v
Ambient conditions, 2-56, 2-62
AMPROLYZER (bus monitor), 6-230
Analog test outputs, 6-228
Standard assignment, 6-229
Supplementary addresses, 6-230
Applications, 1-18
Automatic, 5-141
Axis type, 3-81, 3-82
B
Backlash compensation, 5-161
Bits
for faults, 6-214
for warnings, 6-214
Blocks (FB 10, 11, 12), 3-68
Brake sequence control (from SW 1.4),
5-171, 5-178
Bus communications
Addressing, 4-90
Data transfer via PROFIBUS, 4-90
Establishing the, 3-65
Features, 4-90
Bus monitor, 6-230
Bus termination, 2-42, 2-43
C
C1 master, 4-89, 4-101, 4-104
C2 master, 4-89, 4-101, 4-104
Cable
Changing the outlet direction, 2-40
Example: Prepared, 2-48
for electronics power supply, 2-47
for inputs/outputs, 2-47
for PROFIBUS–DP, 2-46
for the low power supply, 2-46
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition
Cable installation
Example, 2-50
How?, 2-49
Moisture protection, 2-51
Certificates, v
Changeover, Speed/position controlled,
5-134
Changeover, metric/inch, 5-164
Changing the cable outlet direction, 2-40
Characteristic
Ambient temperature, 2-54, 2-59
i2t, 2-32
M/n 300 W motor, 2-58
M/n 75 W motor, 2-54
Closed–loop control structure
n–set mode, 3-84
pos mode, 3-83
Closed–loop position control
overview, 3-83
Standstill monitoring, 5-165
Coincidence factor, 2-31
Communications via PROFIBUS, 1-19, 4-89
Components, 2-25
Connection cover
75/300 W motor, 1-21, 2-39, 2-42
from below, 2-39
from the top, 2-38
withdraw/insert under voltage, 2-32
Connection overview, 2-37
Consistent data transfer, 4-120
Continuous duty S1, 2-55, 2-59
Control authority (from SW 1.5), 3-75
CP 5511, 3-79
CP 5611, 3-79
D
Danger information, ix
Data transfer
Consistent, 4-120
Inconsistent, 4-120
Data type, 4-113, 5-183
DC–PMM, 2-34
Declaration of Conformity, D-255
Device identification, viii
E
E-259
E