User Manual 08/2003 Edition

02.99
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition
2.4 Mounting SIMODRIVE POSMO A
2.4.3 Mounting the prepared cables in the connection cover
How are the
prepared cables
installed?
The following sequence should be maintained when installing the prepared
cables into the connection cover (refer to Fig. 2-23):
1. Release the nut, dummy plugs and terminal insert/seal from the PG
gland.
2. Locate the nut and clamping insert/seal onto the cable.
3. Open–up the shield braiding (remove the insulating foil below).
The shield must cover the O ring by approx. 2 mm.
Cleanly cut–off excessive shield!
4. Assemble the nut with clamping insert/seal.
5. Insert these into the PG gland and tighten the nut.
6. Connect the ends of the cables to the lower side of the connection
cover.
Point 1
Nut
Point 2
Point 3
Point 3
Point 4
Point 5
Ó
Ó
Dummy plugs
Ó
Ó
Ó
Clamping insert/seal
Connection to the PROFIBUS unit
Ó
ÓÓ
ÓÓ
ÓÓ
ÓÓ
Fig. 2-23 How are the prepared cables installed?
2 Installing and Connecting–up
O ring
M20 gland
Shield
M20 gland
Point 6
Wiring at
X20
2-49
2