User Manual 08/2003 Edition

02.99 08.03
2.4 Mounting SIMODRIVE POSMO A
2.4.1 Mounting overview
Mounting and
installation steps
Release the SIMODRIVE
POSMO A connection cover
LED?
dark?
or
red steady light?
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition
2.4 Mounting SIMODRIVE POSMO A
The following steps are required when mounting a SIMODRIVE
POSMO A:
Mount the SIMODRIVE POSMO A motor without connection
cover (refer to the dimension drawings in Chapter C)
Yes
No
Caution:
Protect an open drive
against dirt
Prepare the connection cover for mounting:
Prepare the cable ––> refer to Chapter 2.4.2
Install the cables in the connection cover ––> refer to Chapter 2.4.3
Set the PROFIBUS node address ––> refer to Chapter 2.3.1
Set the PROFIBUS terminating resistor ––> refer to Chapter 2.3.1
Locate the connection cover on the SIMODRIVE POSMO A and tighten the 2 screws
retaining the cover (max. tightening torque, 1.8 Nm)
Connect the protective and potential bonding conductors ––> refer to Chap. 2.3.2
Switch–on the power supply for the load and electronics
Load power supply (if there is no electronics power supply)
Load and electronics power supply (if both of the power supplies are separate)
Fig. 2-16 Mounting steps
2 Installing and Connecting–up
Troubleshooting/diagnostics
––> Refer to Chapter 6
Carry out the start–up procedure
––> Refer to Chapter 3
2-45
2