User Manual 08/2003 Edition

02.99
Entry into
”SimoCom A”
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition
3.2 Commissioning the DP master
Prerequisites:
The parameterizing and start–up tool ”SimoCom A” is installed on the
PG/PC and can be started.
The following basic screen is displayed after the first start:
Fig. 3-6 Basic display of ”SimoCom A”
3 Start–up
Note
This is what you really need to know when using ”SimoCom A”:
The program attempts to ”think with you”:
If you select a command, which is presently not available for a
specific reason (e.g. you are offline and wish to ”move an axis ”),
then the program does what you would probably wish it to do:
It goes ”online”, and offers you a list of drives and after the required
drive has been selected, it opens the traversing window. However,
if you do not wish to do this, then you can exit and continue as
required.
Only the information is provided in the dialog boxes which must be
available as a result of the selected configuration.
Please observe the information on ”SimoCom A” in Table 3-1.
3-73
3