User Manual 08/2003 Edition

02.99 05.03
System
requirements
Un–installing the
C1 master?
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition
3.2 Commissioning the DP master
As a minimum, the following hardware and software environment is
required in order to operate the C1 master:
The PG, PC or Notebook must have
– Operating system: Windows 95 ® /98 ®
– 32 MB RAM memory
– 10 MB free memory on the hard disk
Requirements placed on the communications
– CP 5511 (PROFIBUS coupling via PCMCIA card)
Configuration:
Type 2 PCMCIA card + adapter with 9-pin SUB-D socket to connected
to PROFIBUS.
Order No. (MLFB): 6GK1551-1AA00
– CP 5611 (PROFIBUS connection via a short PCI card)
Configuration:
Short PCI card with 9-pin SUB-D socket to connect to PROFI-
BUS.
Order No. (MLFB): 6GK1561-1AA00
– CP 5613 (PROFIBUS connection via a short PCI card)
Configuration:
Short PCI card with 9-pin SUB-D socket to connect to PROFI-
BUS DP.
Diagnostic LEDs
PROFIBUS controller ASPC2 StepE
Order No. (MLFB): 6GK1561-3AA00
For newer PGs, this communications interface is already included.
Software requirements
– SIMATIC NET,
SOFTNET DP/Windows 98 NT 4.0/5.0 or newer
Order No. (MLFB): 6GK1704-5DW-3AA0
– TCL/TK interpreter Version 8.0
(is included in the installation software)
This is how you can un–install the C1 master from your PG/PC:
3 Start–up
Select the ”control panel”
–> START –> SETTINGS –> CONTROL PANEL
Double–click on the ”Software” symbol
Select the program to be uninstalled
Press the ”add/remove...” button and then follow the instructions
3-79
3