User Manual 08/2003 Edition

6
6 Fault Handling and Diagnostics 02.99 04.01
6.2 Faults and warnings
6.2 Faults and warnings
6.2.1 General information on faults and warnings
Preliminary
comment
Table 6-2 Overview of faults and warnings
Fault bit
Warning bit
P947.0
...
P947.15
P953.0
...
P953.15
P954.0
... (from SW
1.4)
P954.15
6-214
For SIMODRIVE POSMO A, faults and warnings cannot be displayed.
When a fault or warning is detected then this is displayed in the positioning
motor by setting the appropriate status signal and the fault/warning
bits in P947, P953 and P954.
The faults and warnings can be evaluated as follows:
Via PROFIBUS in cycle operation
By reading the status signal and evaluating the bit–coded parameter
values for the faults and warnings (P947, P953 and P954).
Via SimoCom A in online operation
The faults or warnings that have occurred are converted into an appropriate
fault/warning number and displayed.
Fault number
Warning number
for SimoCom A
700
...
715
800
...
815
900
...
915
Status signal Significance
ZSW.3
(faults present)
ZSW.7
(warning present)
ZSW.3 or ZSW.7
Fault 700
...
Fault 715
Warning 800
...
Warning 815
Supplementary information 900
...
Supplementary information 915
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition