User Manual 08/2003 Edition

3
3 Start–up 02.99 05.03
3.2 Commissioning the DP master
Settings for
”SimoCom A”
Example:
Online operation
via PROFIBUS
3-72
PG/PC
For ”SimoCom A”, communications should be set as follows via
PROFIBUS–DP:
Options – Settings – Communications ––> ”Interface” dialog”
With ”For ”Go online” connect via” set the following:
––> ”direct connection”, if the coupling is directly established
or
––> ”routed via S7”, if the coupling is established through the
MPI interface
Online operation can be directly established to the drive directly via the
fieldbus using the ”Go online” function.
Parameterizing
and start–up tool
”SimoCom A”
Setup.exe
MPI
or
CP 5511
or
CP 5611
or
CP 5613
ÄÄ
ÄÄ
SIMATIC S7-300 (CPU: S7-315-2-DP)
PROFIBUS DP
At the last node (in this case at the left) ––> switch in the terminating resistor (refer to
Chapter 2.3.1)
Set the PROFIBUS node address for the slaves (refer to Chapter 2.3.1)
Fig. 3-5 Example for online operation via PROFIBUS: ”SimoCom A” 2 drives
or
First
node
(in this case,
the master)
––>
Switch–in
terminating
resistor
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition