User Manual 08/2003 Edition

02.99 04.01 08.03
P0006 / 06 Software limit switch, start
Siemens AG 2003 All rights reserved
SIMODRIVE POSMO A User Manual (POS1) – 08.03 Edition
5 Description of the Functions
5.6 Parameters for SIMODRIVE POSMO A
300W 075W
Min Standard Max Unit Data type Effective
–200000 –200000 200000 MSR C4 immed.
The parameter specifies the software limit switch, left negative.
de-activated: P6 = P7
activated: P6 < P7
Note:
Also refer to P7.
The following applies from SW 2.0:
Software limit switches are not possible in the ”Speed setpoint” operating mode (P930).
P0007 / 07
300W 075W
Software limit switch, end
Min Standard Max Unit Data type Effective
–200000 200000 200000 MSR C4 immed.
The parameter specifies the software limit switch, right positive.
de-activated: P6 = P7
activated:
Note:
P6 < P7
Also refer to P6.
The following applies from SW 2.0:
Software limit switches are not possible in the ”Speed setpoint” operating mode (P930).
P0008 / 08
300W
Maximum speed
Min Standard Max Unit Data type Effective
0 3000 3800 rpm C4 immed.
Max. motor speed referred to the motor axis
075W
Min Standard Max Unit Data type Effective
0 3000 3600 rpm C4 immed.
Max. motor speed referred to the motor axis.
P0009 / 09
300W 075W
Acceleration time
Min Standard Max Unit Data type Effective
10 100 15000 ms T2 immed.
During this time, in the speed-controlled operation, the setpoint is set as follows:
Ramp-up: From zero up to the maximum permissible actual speed
Ramp-down: From the maximum permissible actual value down to zero
The following applies from SW 2.0:
The ramp-up time can be changed with immediate effect in the ”Speed setpoint” operating mode.
This is also possible when the drive is moving.
P0010 / 0A
300W 075W
Maximum motor velocity
Min Standard Max Unit Data type Effective
0 30000 2000000 MSR/min I4 immed.
Max. permissible velocity, dependent on the system.
The max. speed in P8 was not exceeded in operation.
Note:
This parameter has a gearbox-dependent factory default.
5-187
5