Plan Description - City of Tustin

Chapter 3 • Land Use and Development/Reuse Regulations
Specific Plan by defining appropriate locations for certain land uses and
permitted development intensities. The Land Use Plan includes thirteen
(13) separate land use designations as described in Section 2.2.1. Each
parcel within the Specific Plan has been assigned a specific land use
designation. Each designation has been assigned a Planning Area (PA)
number, as shown on Figure 3-1. The Planning Area is the smallest
regulatory unit for the application of development regulations. The
development standards are customized for each Planning Area and
grouped according to the neighborhood in which they belong.
The Land Use Plan Statistical Analysis is organized in two ways. Table 3-
1 is the Land Use Plan Statistical Analysis organized by land use
designation, and Table 3-2 is the Land Use Plan Statistical Analysis
organized by neighborhood. The neighborhoods of the Plan are shown
again for reference in Figure 3-2. Each statistical analysis contains the
approximate acreages, square footage allocations and dwelling units
permitted in each Planning Area shown on the Land Use Plan. Each
Planning Area is assigned an amount of land devoted to existing buildings
(where applicable), and includes an allocation of land available for new
uses based on the density/intensity standards established in the Specific
Plan. The maximum number of dwelling units and total square footage of
non-residential development provided for in the Specific Plan are
prescribed in the Statistical Analysis and further defined in the following
regulations sections. Calculation of development potential is based on
gross acreage figures for each Planning Area, which excludes land
devoted to arterial roadways as identified in the Circulation Plan (Figure
2-5).
MCAS Tustin Specific Plan/Reuse Plan
City of Tustin
Page 3-4