memory products - Al Kossow's Bitsavers

ETC2732READ OPERATIONDC CHARACTERISTICS TA=OoC to + 70°C, VCC =SV ±S%, VSs=OV, (Unless otherwise specilied)(6)Symbol Parameter Test Conditions Min. TypJl) Max. UnitsIII Input Current VIN=VCC or GND - - 10 ",AILO Output Leakage Current VOUT=VCC or Vss, CE=VIH - - 10 ",AVIL Input Low Voltage -0.1 - 0.8 VVIH(3) Input High Voltage 2.0 - VCC+1 VVOLl Output Low Voltage IOL=2.1 mA - - 0.45 VVOHI Output High Voltage IOH= -400 ",A 2.4 - - VVOL2 Output Low Voltage IOL=O",A - - 0.1 VVOH2 Output High Voltage IOH=O",A Vcc-O.l - - VICCI VCC Supply Current Active CE=OE=VIL(TTL Levels) Input = VIH or VIL - 2 10 mAFrequency 1 MHz, 1/0 = OmAICC2 VCC Supply Current Active CE=OE=VIL (Note 4)(CMOS Levels) Inputs=GND or VCC - 1 5 mAFrequency 1 MHz, 1/0 = OmAICCSBI VCC Supply Current Standby CE=VIH - 0.1 1 mAICCSB2 VCC Supply Current Standby CE=Vcc - 0.01 0.1 rnAAC CHARACTERISTICS TA = OOC to C, VCC = SV ±S% VSS = OV; Unless otherwise specilied)(6).Symbol Parameter Test ConditionsETC2732-3ETC2732 (-V)Min. Max. Min. Max.tACC Address to Output Delay CE/PGM = OE = VIL - 350 - 450 nstCE CE to Output Delay OE=VIL - 350 - 450 nstOE Output Enable to CE/PGM=VIL - 150 - 150 nsOutput DelaytDF(4,5) OE or CE High to CE/PGM=VIL 0 130 0 130 nsOutput Hi-ZtOH Address to Output Hold CE/PGM = OE = VIL 0 - 0 - nsUnitCAPACITANCE (TA= +2SoC, 1=1 MHz) (Note 2)Symbol Parameter Test Conditions Min. Typ. Max. UnitCINI Input Capacitance Except OENpp VIN=OV 4 6 pFCIN2 OENpp Input Capacitance VIN=OV - 20 pFCOUT Output Capacitance VOUT=OV 8 12 pFNotes 1. Typical conditions are lor operation at: TA = 25°C, VCC = VPP = VCC, and VSS = OV.2. Capacitance is guaranteedJly periodic testing. TA = 25°C, I = 1 MHz.3. The inputs (Address, OE, CE) may go above VCC by one volt with no latch up danger. Only the output (data inputs duringprogramming) need be restricted to VCC + 0.3 V.4. The tDF compare level is determined as lollows:High to Hi-Z, the measured VOHI (DC) - 0.10VLow to HI-Z, the measured VOHtJQC) + 0.10V5. TDF is specified from OE or CE which ever occurs first. This parameter is only sampled, not 100% tested.6. TA= -40°C to +85°C for "V" range3/10103