memory products - Al Kossow's Bitsavers

MK41H79(N, P)-20/25/35ABSOWTE MAXIMUM RATINGS'Voltage on any pin relative to GND ....................................... -1.0 V to +7.0 VAmbient Operating Temperature (TA) ......................................... O°C to +70OCAmbient Storage Temperature (Plastic) .................................... -55OC to +125OCAmbient Storage Temperature (Ceramic) .................................. -65OC to +150OCTotal Device Power Dissipation .................................................... 1 WattOutput Current per Pin .......................................................... 50 mA'Stresses greater than those listed under ''Absolute Maximum Ratings" may cause permanent damage to the device.This is a stress rating only and functional operation of the device at these or other conditions beyond those indicatedin the operational section of this specification is not implied. Exposure to absolute maximum rating conditions for extendedperiods of time may affect reliability.RECOMMENDED DC OPERATING CONDITIONS(O"CsTAS70°C)SYMPARAMETERMINTYPMAX UNITS NOTESVccSupply Voltage4.5 5.05.5 V 3GNDSupply Voltage0 00 VVIHLogic 1 Voltage, All Inputs2.2Vcc+1.0 V 3VILLogic 0 Voltage, All Inputs-0.30.8 V 3DC ELECTRICAL CHARACTERISTICS(OOCsT A s70OC) (Vcc = 5.0 V ± 10 percent)SYMIcelICC2ICC3IlLPARAMETERAverage Power Supply CurrentTIL Standby CurrentCMOS Standby CurrentInput Leakage Current (Any Input Pin)MIN-1MAX UNITS NOTES120 mA 416 mA 58 mA 6+1 pA 710L Output Leakage Current (Any Output Pin) -10 +10 pA- 8VOHVOLOutput Logic 1 Voltage (lOUT = -4 mAlOutput Logic 0 Voltage (lOUT = +8 mAlCAPACITANCE(TA = 25°C, f = 1.0 MHz)2.4 V 30.4 V 3SYMClC2PARAMETERCapacitance on input pinsCapacitance on DQ pinsTYP MAX UNITS NOTES4 5 pF 98 10 pF 9NOTES1, Measured with load shown in Figure 6(A).2. Measured with load shown in Figure 6(8).3. All voltages referenced to GND ..4. rCC1 is measured as the average AC current with V CC= VCC (max) and with the outputs open circuit. tRC ..!Be (min) is used.5. CE = VIH, all other inputs = Don't Care.6. VCC (max) 2:CE2:VCC - 0.3 V, all other inputs =Don't Care.7. Input leakage current specifications are valid for all VINsuch that 0 V