memory products - Al Kossow's Bitsavers

MK48Z02/12(B)-12/15/20/25~BSOWTE MAXIMUM RATINGS·Voltage On Any Pin Relative To GND ...................................... -0.3 V to +7.0 VAmb!ent Operating (Vce On) Temperature (TAl ................................. O:C to +70OCAmbient Storage (Vcc Off) Temperature .................................... -40 C to +85OCTotal Device Power Dissipation .................................................... 1 WattOutput Current Per Pin .......................................................... 20 mA·Stresses greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the device.rhis is a stress rating only and functional operation of the device at these or any other conditions above those indicatedn the operational section of this specification is not implied. Exposure to absolute maximum rating conditions for extendedperiods of time may affect reliability.:AUTION: Under no conditions can the ''Absolute Maximum Rating" for the voltage on any pin be exceeded sincet will cause permanent damage. Specifically, do not perform the "standard" continuity test on any input or output pin,.e do not force these pins below -0;3 V DC.FtECOMMENDED DC OPERATING CONDITIONS:OOC~TA~70OC)SYMPARAMETERMINMAX UNITS NOTESVceSupply Voltage (MK48Z02)4.755.50 V 1VceSupply Voltage (MK48Z12)4.505.50 V 1GNDSupply Voltage00 V 1VIHLogic "1" Voltage All Inputs2.2Vcc + 0.3 V V 1VILLogic "0" Voltage All Inputs-0.30.8 V 1,2I)C ELECTRICAL CHARACTERISTICS:OOC~TA~+70°C) (Vcc (max)~Vcc~Vcc (min»SYMICClIcc2PARAMETERAverage V ce Power Supply CurrentTIL Standby Current (E = VIH)Icc3 CMOS Standby Current (E~Vec-0.2 V)IlLIOLVOHVOLInput Leakage Current (Any Input)Output Leakage CurrentOutput Logic "1" Voltage (lOUT = -1.0 mAlOutput Logic "0" Voltage (lOUT = 2.1 mAl::APACITANCE (T A = 25°C)SYM PARAMETERC I Capacitance on all pins (except 0/0)CO/QCapacitance on 010 pinsMIN-1-52.4MAX UNITS NOTES80 mA 33 mA1 mA+1 pA 4+5 pA 4V0.4 VMAX NOTES7 pF 510 pF 4,5.OTESI. All voltages referenced to GND.!. Negative spikes of -1.0 volts allowed for up to 10 ns once per cycle.I. ICC1 measured with outputs open.k Measured with GNDsVp;;VCC and outputs deselected.i. Effective capacitance calculated from the equation C = l.