HP OpenView Operations Administrator's Reference - filibeto.org

About OVO Security
About Network Security
4. Set up each managed node.
On each OVO managed node that requires DCE authentication of
RPCs, run one of the following scripts:
Remotely
If automatic password generation has been disabled for the
managed node, on the management server enter the following:
/opt/OV/bin/OpC/install/opc_sec_register.sh \
...
Locally
On each of the managed nodes, enter the following:
/opt/OV/bin/OpC/install/opc_sec_register.sh
NOTE To undo any of the scripts, use the -remove option.
5. Set or change security levels for the server or nodes.
Use the OVO GUI to set or change the security levels for the
management server or managed nodes with DCE RPCs. By default,
the security level is set to No Authentication of RPCs.
CAUTION To set or change the security level, the domestic version of DCE (U.S.
and Canada only: dced.Dom) must be installed. If you select a DCE
Security Level in the Communication Options window, but have no
domestic version installed, the communication between the OVO
agent and the management server will fail. If this happens, set the
DCE Security Level to No Authentication of RPCs, and remove
the entry in the nodeinfo file of the RPC-based managed node, or
use the ovconfchg command-line tool on HTTPS-based managed
nodes, refer to the OVO HTTPS-Agent Concepts and Configuration
Guide and ovconfchg man page for more information. Finally,
manually restart the OVO agents.
Chapter 12 487