HP OpenView Operations Administrator's Reference - filibeto.org

Administration of the OVO Management Server in a Cluster Environment
Troubleshooting OVO in a Cluster Environment
Troubleshooting OVO in a Cluster
Environment
HA Resource Group Cannot Be Started on a
Particular Cluster Node
Using the Tracing Option
If HA Resource Group cannot be started on one of cluster nodes, first try
to resolve this problem by enabling the trace option. Perform the
following steps:
1. Make sure that HA Resource Group is not running on any cluster
node. If the HA Resource Group is running, stop it with the following
command:
/opt/OV/lbin/ovharg_config ov-server -stop
2. Enable tracing by entering:
/opt/OV/lbin/ovharg -tracing ov-server enable
3. Enter the following command:
/opt/OV/lbin/ovharg_config ov-server -start
If you receive the output 0, the OVO management server has been
successfully started. If the output is 1, the start operation failed. To find
out more about the causes of the problem, check the output of the trace
file:
/var/opt/OV/hacluster/ov-server/trace.log
If the OVO management server failed to start, perform the steps
described in the section entitled “Manual Operations” on page 590.
Chapter 14 589