HP OpenView Operations Administrator's Reference - filibeto.org

Installing OVO Agents on the Managed Nodes
De-installing OVO Software from the Managed Nodes
c. Click the Yes button.
The software de-installation script, inst.sh(1M), is run in an
additional terminal window. This script verifies that all deleted
managed nodes are accessible by root. If passwords are missing,
you will be prompted to enter them. During script execution,
errors or warnings requiring your attention may occur.
Verify the overall result of the script.
d. Press the Return key.
The terminal window closes.
2. Check the local de-installation logfile.
Check the local (managed node) de-installation logfile for any
problems.
For the location of the logfile on your managed node, see the OVO
DCE Agent Concepts and Configuration Guide.
To De-install the OVO Agent Software Manually
Note that you can also manually de-install the OVO agent software
which is, however, only supported on selected managed node platforms.
To de-install the OVO agent software manually, follow these steps:
1. Stop all OVO agents running on the managed node.
2. Enter commands to de-install the software.
To find out which command to enter for to the platform from which
you are de-installing the software, see the OVO DCE Agent Concepts
and Configuration Guide.
NOTE After manually de-installing the OVO software from a managed node,
you must enter the following command on the management server:
opcsw -de_installed
Chapter 1 65