JOINT FLEET MAINTENANCE MANUAL

VI-8.2.3 Miniature/Micro-miniature
Electronic Repair Program
VI-9.2.5 Metrology and Calibration
Program
VI-11.5.3 Maintenance, Repair and
Overhaul of Service Craft,
Landing Craft and Small
Boats
I-FWD-C-23
COMFLTFORCOMINST 4790.3 REV A CH-4
• Establish 2M program under cognizance of
Electronics Material Officer and Combat
Systems Officer
• Maintain certified 2M stations and technicians
• Screen and repair all CCAs/Ems
• (Aircraft Carriers) establish MTRF with an
overall coordinator
• (Aircraft Carriers) maintain an active MTRF
• Maintain high degree of TAMS calibration
readiness
• Appoint a calibration coordinator
• Ensure only operational TAMS are submitted
for calibration
• Perform repair of TAMS within capability of
Ship's Force
• Maintain calibration readiness goal
• Coordinate planning aspects of craft and/or
boat overhauls with TYCOM/ISIC
• Prepare and submit overhaul progress reports
• Ensure enough trained personnel are assigned
to on-site monitoring of crafts and boats
• Fulfill responsibilities for safety of craft and
personnel
VI-12.3.2.2 Degaussing • Maintain ship's installed degaussing system
• Maintain ship's degaussing folder
VI-12.4.1.2 Degaussing (Submarines
• Ensure magnetic signature minimized by
without degaussing systems)
periodic check ranging
• Inform ISIC of unsat ranging
• Maintain ship's degaussing folder
• Undergo flash deperming as directed
• Before flash deperming prepare ship's
equipment and off-load sensitive material
VI-16.2.2.1.5 Habitability Improvement • Report deficiencies to TYCOM
• Assign project manager and petty officer
supervision
• Assign labor force for removal, space
preparation and installation
• Conduct training programs
• Accept delivery, store and account for
materials
• Maintain custody of tools for removal and
installation
• Report changes to Naval Inventory Control
Point
• Report completion to TYCOM
• Ensure ship's selected records are updated