JOINT FLEET MAINTENANCE MANUAL

COMFLTFORCOMINST 4790.3 REV A CH-4
• Receipt inspect package alteration kits that
contain controlled material when ready for use
• Control previously rejected and now accepted
controlled material as required
• Retain custody of controlled material when it is
not in the custody of a craftsman or in a
controlled material storage area
• Ensure controlled material markings are on all
pieces when cutting a smaller piece from a
large one
• Ensure controlled material markings are moved
to an unaffected area, if the controlled material
item will lose the markings due to a fabrication
process (e.g., welding, machining) prior to the
fabrication process
V-I-6.3.4 Receipt Inspection of
Controlled Material
• Receipt inspect controlled materials as required
V-I-6.3.5 Receipt Inspection of Open
Purchase or Locally
Manufactured Material or
Upgrading Supply System
Material to Level I
• Receipt inspect materials as required
V-I-6.3.8 Level I/SUBSAFE Stock
Program Material
Downgrading
• Remove markings as required
V-I-6.3.9 Storage, Issue, and Handling • Inspect controlled material storage areas as
of Level
required
I/SUBSAFE/Submarine Flight
Critical Component Stock
• Maintain custody of controlled material as
required
Program Material
• Verify transfer of MIC markings as required
V-III-6.3.1 Control of SOC Material • Maintain custody of SOC material as required
V-III-6.3.3 Receipt of SOC Material • Receipt inspect SOC material as required
I-FWD-C-30