requirements contracts for engineering design and related services ...

More documents

Recommendations

Info

the Consultant, it is infeasible to comply with the 2% maximum sidewalk cross slope and 5% maximum longitudinal ramp slope requirement(s) of the Americans with Disabilities Act Accessibility Guidelines; f) In conjunction with the mitigation of adverse property and street impacts (including substandard longitudinal gutter grades, street trees, shrubs, fences, walls, sidewalk removals, addition of entrance steps and access/egress solutions) the Consultant shall develop the "best technically feasible fit" top of curb for each block face and each individual property and intersecting street, through the performance of a detailed grade analysis and design, which shall consist of an intensified study and a reiterative design process for proposed grades on curb and sidewalk, and integrating into the detailed design process all of the factors listed above which will affect the desired solution; g) Perform topographic surveys to obtain additional survey data including spot elevations to "fully support" the detailed grade design and reiterative grade design process where needed; h) Locate and plot customized profiles, which shall require pre-approval by the City, for the purpose of executing the detailed analysis and design of project grades. Locate and plot customized cross sections, which shall require approval by the City, for the purpose of executing the detailed analysis and design of project grades; i) Develop/design roadway crowns and/or cross slopes within the framework of Departmental or other approved standards and the existing crowns and cross slopes for streets abutting and/or intersecting the project limits; j) Design sidewalk pavement grades at and into all intersections and terminal streets to meet the existing conditions and/or the proposed design in each intersecting street. The application and/or use of transition areas to satisfy this design requirement shall, for the purposes of this program, not be considered an adequate level of study and or design; k) Reiterate the foregoing grade study and design requirements, until a "best fit" grade design is achieved, including, but not limited to: the plotting and study of additional profiles; plotting and study of additional cross sections, the securing and study of additional topographic data as described above, and as needed to meet/comply with the specific site constraints and specific site issues including, but not limited to, street/roadway drainage, required cover for storm sewers, drainage of private properties, and the Americans with Disabilities Act Accessibility Guidelines; l) Incorporate and integrate the proposed design grades into the composite Contract Drawings and with other affected project components; m) Prepare a "grade change exhibit" for the entire project site, in accordance with the current DDC standards and requirements in the standard format prescribed by the Department in coordination with the Topographical Bureau of the respective Borough President's Office, identifying all locations where the proposed design grades vary from the existing Legal Grades. Information regarding Legal Grade Maps and samples of Legal Grade Maps for different Boroughs is included on the following pages. NYC Department of Design and Construction Infrastructure, October 2012 GR-51
NYC Department of Design and Construction Infrastructure, October 2012 GR-52
Page 1 and 2:
REQUEST FOR PROPOSALS PIN Project P
Page 3 and 4:
PROJECT: HWDRMX02L, HWDRKR02L, HWDR
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Tax ID # : PIN # : 8502013VP0008P-1
Page 43 and 44:
Tax ID #: PIN #: 8502013VP0008P-10P
Page 45 and 46:
Page 47 and 48:
Page 53 and 54:
THE CITY OF NEW YORK DEPARTMENT OF
Page 55 and 56:
1.9 ―Consultant‖ or ―Contract
Page 57 and 58:
4.4 Final Task Order: Following the
Page 59 and 60:
(a) (b) Inclusion in Staffing Plan:
Page 61 and 62:
6.4 Provisions Regarding Engineerin
Page 63 and 64:
Article 6.5), (b) expenses for time
Page 65 and 66:
method of payment for the performan
Page 67 and 68:
to have an Assigned Employee(s) per
Page 69 and 70:
7.6 Requisitions for Payment 7.6.1
Page 71 and 72:
Agency by e-mail at poped@ddc.nyc.g
Page 73 and 74:
(g) Timely written requests for ass
Page 75 and 76:
IN WITNESS WHEREOF, the parties her
Page 77 and 78:
EXHIBIT A CONTRACT INFORMATION Div
Page 79 and 80:
EXHIBIT C TITLES AND ALL INCLUSIVE
Page 81 and 82:
EXHIBIT D: MINIMUM REQUIREMENTS PER
Page 83 and 84:
Duties: The CIH will act as the lea
Page 85 and 86: EXHIBIT F GENERAL REQUIREMENTS FOR
Page 87 and 88: (NO TEXT ON THIS PAGE) NYC Departme
Page 89 and 90: GENERAL REQUIREMENTS FOR DESIGN SER
Page 91 and 92: (e) (f) (g) (h) (i) miles from whic
Page 93 and 94: L. The Consultant shall thoroughly
Page 95 and 96: (a) Upon written notice to proceed,
Page 97 and 98: eview submitted design documents (i
Page 99 and 100: utility survey documentation; traff
Page 101 and 102: 3. Surface drainage structures and
Page 103 and 104: Measurement methods, other than ele
Page 105 and 106: c. The Consultant shall submit to t
Page 107 and 108: In order to ensure that the electro
Page 109 and 110: e) Indicate all existing lane delin
Page 111 and 112: iv) Make reasonable attempts to suf
Page 113 and 114: 2. Sub-cellar/sub-basement vaults s
Page 115 and 116: e) The Consultant shall reconcile o
Page 117 and 118: j) The Consultant shall identify al
Page 119 and 120: g) Coordinating with property owner
Page 121 and 122: 11. The Consultant shall prepare a
Page 123 and 124: through the use of CCOs. In additio
Page 125 and 126: under the ensuing construction cont
Page 127 and 128: B. SEWER DATA SURVEY 1. The Consult
Page 129 and 130: e) Include the streets, parkways an
Page 131 and 132: 3. PHASE I TESTING This may include
Page 133 and 134: ) Develop/design project curbs in c
Page 135: 15. Upon completion of the detailed
Page 139 and 140: NYC Department of Design and Constr
Page 141 and 142: NYC Department of Design and Constr
Page 143 and 144: 8. The Consultant shall prepare a l
Page 145 and 146: g) Present the proposed tree planti
Page 147 and 148: p) The Consultant shall prepare Fin
Page 149 and 150: c) During design, confer and meet w
Page 151 and 152: ) The Consultant shall determine th
Page 153 and 154: c) The Consultant shall meet with a
Page 155 and 156: permits, etc. Additionally, the cen
Page 157 and 158: 4.29 BUILDINGS RESEARCH 1. Under th
Page 159 and 160: d. The Consultant shall develop con
Page 161 and 162: (i) The preparation of Preliminary
Page 163 and 164: (k) The Consultant shall incorporat
Page 165 and 166: 8. Natural resources (Refer to Chap
Page 167 and 168: In preparing the ULURP application
Page 169 and 170: 6. The Consultant shall notify the
Page 171 and 172: 4.38 DRAINAGE PLAN GRADE IMPACTS AN
Page 173 and 174: 1) Gather and study all available i
Page 175 and 176: EXHIBIT G: REQUIREMENTS FOR FEDERAL
Page 177 and 178: (1) RECORDS RETENTION APPENDIX A-2:
Page 179 and 180: discriminate in hiring against any
Page 181 and 182: contracting agency shall waive the
Page 183 and 184: EXHIBIT H NYSDOT PROCEDURES FOR LOC
Page 185 and 186: APPENDIX A GENERAL PROVISIONS GOVER
Page 187 and 188:
ARTICLE 8 - PROTECTION OF PERSONS A
Page 189 and 190:
Appendix A (Architects and Engineer
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217:
show all

requirements contracts for engineering design and related services ...

Create successful ePaper yourself

Delete template?

Save as template?