TrainController Gold and Silver - Freiwald Software

!
!
The whole procedure is repeated until the speed step that corresponds to the specified
maximum speed has been measured.
There must not be any “dead gap” between the occupancy sections. That means
the track sections must be located close together. Track section “Centre” must begin
where the other track sections end and vice versa.
Please ensure, that the indicator associated with “Centre” is turned off whenever
the engine reverses direction between two runs of the procedure. There are additional
options, with which the run-out and the pause between two passes of the
measurement can be adjusted. If indicator “Centre” is not turned off when the engine
reverses direction then increase the run-out or pause, respectively.
It does not matter, though, whether the indicator, that is associated with the track section
where the engine just reverses its direction, is turned on or off, when the direction
is reversed.
Diagram 78: Measuring the Speed Profile with occupancy sensors
117