TrainController Gold and Silver - Freiwald Software

• Wire the analog turntable according to the instructions in the Help menu of
TrainController.
• A Turntable Window is created and the track layout of the turntable is configured
accordingly.
• Create a feedback indicator “Track 1” that is turned on, when the physical bridge
of the turntable reaches the position of track 1. Of course you need an appropriate
physical sensing device on your model railroad layout that is able to detect and report
when the bridge reaches this position. This indicator is used to trigger stopping
of the bridge at the destination position.
• Create an on-off switch “Track 1”. This on-off switch is used to trigger turntable
movement and to act as a memory in order to stop the bridge at the correct position.
• Assign the move of the turntable bridge (in any direction) as operations to the onoff
switch “Track 1”.
• Assign the on-off switch “Track 1” as turntable operation to the turntable according
to the image below.
314
Diagram 183: Assigning operations of a on-off switch to a turntable