TrainController Gold and Silver - Freiwald Software

62
Diagram 46: Specifying a Waiting Time
Enter 00:02:00 in the box below Waiting Time. This tells the software, that the train is
to wait 2 simulated minutes in “Block 2”. The duration of simulated minutes is scaled
with the speed of the internal fast clock. For more information about the fast clock refer
to chapter 13, “The Clock”. Commit your settings with OK. Perform the same steps for
“Block 3” to specify a waiting time for “Block 3”.
Now press . The train will now start to move towards “Block 3”. In “Block 3” it
slows down and stops for a while. Then it starts again and enters “Block 4”. Here it
slows down again, stops and starts in the opposite direction. In “Block 2” it slows down
and stops again. After a while it starts again and runs to “Block 1”, where it stops. Then
the complete cycle is repeated again.
You are now able to configure control of automatically running trains. Beginning with
Running with Interlocking you can easily run a train automatically without further
measures. AutoTrain by Drag & Drop provides more control over, where trains will go.
The AutoTrain Symbol bar, that we used in the last step, provides full control of the
train during it’s automatic run.