Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>TNC</strong> Dialog Display<br />
LIMIT Z-<br />
LIMIT Z+<br />
LIMIT IV-<br />
LIMIT IV+<br />
LIMIT V-<br />
LIMIT V+<br />
4CTL X<br />
4CTL Y<br />
4CTL Z<br />
4CTL IV<br />
9CTL V<br />
joftware Number:<br />
\lC<br />
:_rrrml<br />
‘LC -rm-n Lu<br />
IPERATING MODE<br />
tiE FE1 FEZ EXTI EXTZ<br />
3 0 0 0 0<br />
3AUD RATE<br />
-E<br />
:XTl<br />
:XT2<br />
Press Key<br />
>END<<br />
Soft key<br />
RS232/RS422<br />
SETUP<<br />
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
Issue: 01.09.1995<br />
Page 91 .I<br />
Remarks<br />
Note down the limit values<br />
(Do not forget the algebraic sign!)<br />
Note down the preset values<br />
!Do not forget the algebraic sign!)<br />
:key on VDU)<br />
\lote down the NC and PLC software<br />
wmbers<br />
Vlark the operating mode of the<br />
%S232 interface<br />
dote down the Baud rates of the<br />
3S232 interface
Change language