Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Function MP A B C D E F Input AE-6
No. Bit Entry Value
%0011111
Multifunctional parameters 7680
(31)
• memory function for axis direction keys 0 Š Š Š Š Š Š 0 = not stored
+1 = stored
• re-approaching the contour 1 Š Š Š Š Š Š 0 = inactive
+2 = active
• block scan 2 06 09 Š Š Š Š 0 = inactive
+8 = active
• block scan interrupted by STOP or M06 3 09 12 Š Š Š Š 0 = interruption active
+16 = interruption inactive
• with block scan in a TAPPING cycle, the
dwell time to reverse the direction of
rotation is waited to end
4 19 12 Š Š Š Š 0 = dwell time is waited to end
+8 = dwell time is not waited to end
• start of calculation with block scan 5 Š Š Š Š Š Š 0 = start at cursor position
+32 = start at beginning of program
• tool length for blocks with surface normal
6 - - - - - Š 0 = without DR2 from tool table
vector
+64 = with DR2 from tool table
0 to 7
Memory test after power-on
7690
Š Š Š Š Š Š
RAM
EPROM
0
1
+0 = test
+1 = no test
+0 = test
+2 = no test
RH
1.0 TNC 407/415 Machine Parameters MP 7680 - MP 7690 08.05.95 10.2 61
%11
(3)