Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Function MP A B C D E F Input AE-6
No. Bit Entry Value
Overlapping factor for
pocket milling
7430* Š Š Š Š Š Š 0.1 to 1.414 1
Tolerance range for circle end point
(linear contour)
7431* - - Š Š Š Š 0.0001 to 0.016 [mm] 0.01
Output of M-functions 7440*
Programmed stop with M06 0 Š Š Š Š Š Š +0 = program halt with M06
%01011
+1 = no program halt with M06
(11)
Output of M98, modal cycle call 1 Š Š Š Š Š Š +0 = no cycle call, normal code transfer of
M89 at beginning of block
+2 = modal cycle call at end of block
Axis standstill when an M-function is output
2 Š Š Š Š Š Š +0 = program halt until acknowledgement
Exception: axis standstill always occurs
of M-function
with M-functions that result in a pro-
+4 = no program halt, TNC does not wait
grammed stop (e.g. M00, M02 ...) or with
a STOP or a CYCL CALL block
for acknowledgement
Select Kv factors with M105/M106 3 - - - - Š Š +0 = function not active
+8 = function active
Reduced feed rate in the tool axis with
4 - - - - Š Š +0 = function not active
M103
+16 = function active
Position for tool exchange (from
7450
- - 09 09 08 Š 0 = position ignored
%00000
MP951.X) during block scan X
0
+1 = position of X axis taken into account
(0)
Y
1
+2 = position of Y axis taken into account
Z
2
+4 = position of Z axis taken into account
IV
3
+8 = position of IV. axis taken into account
V
4
+16 = position of V. axis taken into account
Constant feed rate in corners 7460* Š Š Š Š Š Š 0 to 179.9999 [°] 10
Display mode and software limit
7470* Š Š Š Š Š Š 0 = 0 to ± 359.999° (no software limit switch 0
switches for rotary axis
monitoring)
1 = 0 to ± 99 999.999°
* accessible via code number 123
RH
1.0 TNC 407/415 Machine Parameters MP 7430 - MP 7470 08.05.95 10.2 54