Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Kundendienst<br />
HEIDENHAIN<br />
<strong>DR</strong> JOMNNES HmmwAIN Gmbli<br />
D-83292Traunreut~~fO8669131-0<br />
SERVICE MANUAL <strong>TNC</strong> <strong>407</strong>/<strong>415</strong><br />
Issue: 01.09.1995<br />
Page 69<br />
In general only the files in the RAM must be stored on an external data medium.<br />
(Note down the file name of the ASCII file xxx.A in the interface mode FE2. as the <strong>TNC</strong> cannot display<br />
the directory of the external data medium.)<br />
Switch <strong>TNC</strong> to operating mode EDITING<br />
(key on VDU)<br />
Prepare <strong>TNC</strong> for input of code number<br />
Enter code number, acknowledge with ENT<br />
Activate data transfer menu<br />
Soft key >SHOW ALL< to display all file types<br />
Use arrow key at the VDU to switch the soft-key<br />
row to the desired extension<br />
Soft key >.XXX FILES< for desired extension<br />
Switch soft-key row back to data transfer menu<br />
If necessary: select desired file with arrow key<br />
If necessary: rename file with soft key<br />
>RENAME< (see 15.3.5)<br />
Soft key >TRANSFER< to transfer data<br />
Soft key >END< to end data transfer menu<br />
<strong>TNC</strong> is in the operating mode EDITING<br />
Several programs with the extension .PLC may be stored in the RAM.<br />
The selected program is marked by an “S” in the status window. Note down the<br />
program name so that you can re-select it after the downloading process.