Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Tapping
Function MP A B C D E F Input AE-6
No. Bit Entry Value
Minimum feed override when
tapping
7110.0 Š Š Š Š Š Š 0 to 150 [%] 95
Maximum feed override when
tapping
Dwell time for change of
7110.1 Š Š Š Š Š Š 0 to 150 [%] 105
direction of spindle rotation
in a tapping cycle
Spindle deceleration time in a
7120.0 Š Š Š Š Š Š 0 to 65.535 [s] 0
tapping cycle (only effective with
BCD output of the spindle speed)
Spindle slow-down time after
7120.1 Š Š Š Š Š Š 0 to 65.535 [s] 0
reaching the total hole depth 7120.2 Š Š Š Š Š Š 0 to 65.535 [s] 0
Tapping without floating tap
holder
• run-in behaviour of the spindle 7130 - - Š Š Š Š 0.001 to 10 [°/min] 0.5
• transient response of the spindle
during acceleration 7140 - - Š Š Š Š 0.01 to 0.999 0.15
Positioning window of the tool
axis 7150 - - Š Š Š Š 0.0001 to 2 [mm] 0.05
Spindle orientation at the
beginning of cycle 17 "Rigid
Tapping"
7160 - - - - 08 Š 0 = spindle orientation is executed
1 = spindle orientation is not executed
RH
1.0 TNC 407/415 Machine Parameters MP 7110.0 - MP 7160 16.01.95 10.2 38
1