Service Manual TNC 407 / TNC 415 - heidenhain - DR. JOHANNES ...

Function MP A B C D E F Input AE-6
No. Bit Entry Value
Cancel status display and
7300* I06 I09 - - - - 0 = status display and Q-parameters are
0
Q-parameters with M02, M30 and
not cancelled
END PGM
1 = status display and Q-parameters are
cancelled
Cancel status display and
Q-parameters
7300
• cancel status display with M02, M30 and
0 06 09 Š Š - - +0 = status display is not cancelled
END PGM
+1 = status display is cancelled
• cancel Q-parameters when program is
1 06 09 Š Š - - +0 = Q-parameters are cancelled
selected
+2 = Q-parameters are not cancelled
Selective erasing of
• status data (S)
• TOOL data (T)
• Q-parameter values (Q)
7300
0
1
2
- - - - Š Š 0 to 7
0 =
1 =
end of program
S Q T
- - -
program selection
- - -
- - -
0
with M02, M30, END PGM
2 = S Q T
- Q -
3 = - Q -
- Q -
4 = S Q T
- - T
5 = - - T
- - T
6 = S Q T
- Q T
7 = - Q T
- Q T
- = data are erased
Graphics display
7310*
• view in three planes
0 Š Š Š Š Š Š +0 = German standard
+1 = American standard
• rotating the coordinate system in the
+0 = no rotation
working plane 1 Š Š Š Š Š Š +2 = coordinate system rotated by +90°
• BLK form after datum shift
+0 = BLK form is not shifted
2 - - - - Š Š +4 = BLK form is shifted
• show cursor position in "view in 3 planes" 3
+0 = cursor is not displayed
- - - - Š Š +8 = cursor is displayed
* accessible via code number 123
RH
1.0 TNC 407/415 Machine Parameters MP 7300 - MP 7310 16.01.95 10.2 45
0